enx magazine

03-91           

Recent Fault Log (Shows faults in chronological order starting with the most recent.

03-92           

Fault Log (# of occurrences of each fault code since log was last cleared).

06-02

Vertical Magnification (range is 0-40mm).

07-00

Cut Length Adjustment.

07-60

Delay between Film Prints.  Increases the time delay between making prints on Film Media (1-30 seconds).

08-09

Enable or Disable the Stack Height Sensor.

08-60

Image Registration (range is 0-40mm).

09-04

Automatic ESV (Electrostatic Voltage) Setup (this test steps through a test and displays values when complete). 

09-06

Tone Up / Tone Down (adjusts concentration to set point).

09-21

Electrostatic setup. * (read below for details)

09-22

Disables toner faults (select ‘Yes’ for running with toner faults, then use code 03-61 to exit to run mode).

09-26

Reset Toner Control Bias to default.

09-55

Test Pattern from memory (9 patterns available).

09-70

Adjust test pattern (used to help when testing the LED bar (code 09-21 option 5) … allows you to change between two different patterns to see if the LED array changes appropriately).

10-04

Fuser Run Test (automatically warms up the fuser and displays the thermistor readings (both the edge and center readings) in Fahrenheit and Celsius mind you! Once up to run temperature, the Drum / Developer and Fuser Drive Motors are switched on… All interlocks must be closed for this test to run).

10-26

Resets the Fuser Control NVM (memory settings) to the default settings.

10-30           

Reset Oil Web counter.