enx magazine

Code:

Description

01-100

Right side door open.

01-200/300/400

Tray 2 / 3 / 4 access door open.

01-500

Finisher front door open.

03-xxx Codes

Communication and Software faults.

04-100

Tray 1 Elevator troubles.

04-200/300/400

Tray 2 / 3 / 4 elevator problems.

04-500

Main Motor drive problem (often something is bound up and keeping the motor from turning).

04-800

Duplex Fan failure.

04-910

Power Supply Fan failure.

05-100 thru 900

Document Feeder (DADF) jams.

05-920

Document Feeder top cover / door interlock open.

05-930

Document Feeder exit door interlock open.

06-100/200

Laser Unit (LSU) errors.

07-xxx

Paper Supply problems such as tray interlocks open or paper supply low or empty.

08-xxx

Paper jams.

09-100

Toner low.

09-200

Toner empty condition sensed.

09-210

Toner sensing problem.

09-220

Toner Count is expired (the CRUM’s counter is up).  Replace the Toner Cartridge to reset. 

09-230/240/250/500

Problems with the Toner Ctg. CRUM (Customer Replaceable Unit Monitor) / Radio Frequency (RF) chip.

09-300

Drum warning (new end of 55K life)

09-310

Drum cartridge drum is not turning properly. (check the drum and the drives to the drum’s drive coupling)

09-320/330/340/600

Drum Cartridge CRUM (chip) failure.

09-400

Drum Cartridge end of life.

09-700

Toner supply error (Toner is not making it from the toner cartridge to the xerographic module / drum ctg.)

09-800

Wrong Toner Cartridge detected (incompatible CRUM chip)

09-900

Wrong Xerographic Module (Drum Ctg.) (incompatible CRUM chip)

10-100/200

Low fuser temperature detected.

10-300

Fuser Overheat problem.

10-400

Fuser fault (the manual is not all that specific on this code).

12-100/200/300/400

Finisher jams.

12-500

Finisher exit tray is full.

12-600/610

Stapler problems.

12-700

Finisher compiler paddle fault.

12-710/720

Finisher jogger faults.

12-730

Finisher support finger home sensor fault.

12-740

Finisher ejector failure.

12-750

Finisher stapler fault.

12-760

Finisher stacker fault

14-100

CCD / Scanner carriage is locked.  Check the slide latch which is designed to be used during shipping… It’s located underneath the Scanner Bed, just above where the paper exit tray is found.